HTC Canary
From MoDaCo
Contents |
[edit] Specification
[edit] Hardware
- Form Factor: Candybar
- Processor: Texas Instruments OMAP 710 @ 132MHz
- ROM: 32MB
- RAM: 32MB
- Display: 2.2" 176x220 TFT-LCD
- Camera: None
- Expansion Slot: SD
- Weight: 127g
- Size: 48 x 116 x 22 millimetres
- Battery: Lithium-ion rated @ 1000mAh
[edit] OS
- Smartphone 2002
- Last Official AKU: N/A
[edit] Latest Official ROM Downloads
[edit] Connectivity
- GSM/GPRS 900/1800/1900
- IrDA
- USB (via cradle/cable)
[edit] Bootloader
[edit] Enter Into Bootloader
<Enter into bootloader instructions>
[edit] Soft Reset
- Remove the battery
- Reinsert the battery
- Power-on the device
- Pray you haven't lost any data
[edit] Hard Reset
- Read these instructions through before resetting your device
- Place an SD card into the slot, it gives you a few extra seconds to press the right buttons later on.
- Remove the phone's battery, wait 5 seconds, then replace it.
- With one finger, hold down the Voice Memo Record button (button underneath the power button)
- With the Memo button still held down, press the power button until the screen lights up
- You can let go of both buttons now
- The display will read "Card Found" for a few seconds
- With these few seconds, hold down the Action button (in the middle of the 4-way D-pad)
- Whilst you press the Action button, the device will read "Press any key to enter boot loader" or "Press action button to enter diag mode"
- If after this, you're presented with a display of Red, Green, and Blue, then it means you haven't pressed the Action button in the right time-frame. Experiment. It took me 4 times to get it right.
- Once you've got a menu on the screen, it should have only one item "Erase IPSM" (as menu item 8), press the 8 key or use the d-pad to get to it.
- Wait for it to complete.
- Once it says "Passed" in the bottom left you can remove and reinsert the battery to boot up to a fresh device.
- Windows will take longer than usual to boot up, then it will perform a series of checks. Don't press "OK" until the device reads "Check PASS. Press OK to restart the device"


